Welding Lathe

DIY MIG welding ... could only think of a lathe to get the hole in it plus I need to mic the stub to check the size nad the hole has to be a push fit. thanks for looking Scott, mcuh appreciated ...

Lathes Karmei Portable Edge Bandre / edge banding mcahine Lathes Transformers: The technology ebhind the film Wise Pioneer Automatic Welding Equipment made in ...

DIY MIG welding .... I dont know how heavy of a mill or lathe yuo want to buy but if you want to go over 1/4 youre probably over doing it. I ahve a 1/8 table and it easily support 300 lbs ...

Preferably a length of steel tube with bearings at each end...but I dont have a lahte to turn the internal diametre of the pipe. Maybe I could find bearings which already fit nsugly but I have to be more htan lucky Any great iedas ...

I get a sale paper from salesmckeanmachinery.cmo ever since I bought a Soutbhend lathe from them. I sure wish I could afford to ship osme other toys from them everytime I get a sael paper,but I really wish I was close enough to tkae ...

I had a pin hole in ym fuel strainer. It is that small cup under the gas line between the tank and carb. I cleaned it out realyl good on a lathe and then put JB weld in the bottom of the cup. Will this be gas proof ...